Taurus tube

Running the taurus test program

The software normally installs (windows based) into <code>C:\embedinc\</code>. Identify the serial port connected to the tube side board and run as follows:

<pre> C:\embedinc\com>test_taurus.exe -sio 39 </pre>

Note the executable is in the <code>com</code> subdir. Issuing a "?" to the program will give a list of the commands supported.

Useful commands

• fwinfo firmware version
• r report current and voltage
• hv (on,off,auto) hv enable
• kv (n) set voltage to (n)
• ua (n) set current to (n)
• log start logging file
• unlog stop logging file

To use the logging info either look at the log file or use the following command in the "com" directory: <pre> csvplot curr </pre>

---

Main_Page Main Thermo Previous (Thermo)